 |
| Would you like some miniature with your flash? |
The build process of the Creature Caster figures was annoying. Full stop. The fidelity of the arm and wrist joins were very low, and super fiddly. As stated previously, the arms were not numbered on the tree, (the web page shows some numbering, but this must be a newer tree as my limbs had none), so many of the figures needed to be assembled by examining Creature Caster's web photos. This is tedious and annoying. Just provide better trees!
I would encourage a potential buyers to scrutinize the web photos. The photo below is a screen rip from Creature Caster's own web page (without permission). The type and magnitude of failures I'm describing are clearly obvious.
 |
| Actual product advertisement! |
This is the norm, not the exception. Note fit. Note finish. Note "cleaned" mold lines.
Remember BONES... SiOcast is almost that bad. It can be sanded to some degree, but not well. It cuts easily (easier than BONES). It's too soft to clean with the old, "scrape the blade" kind of approach. On the upside it does glue well with superglue, but the set time is long, so use some kind of accelerator, or be patient. It also binds well with Tamiya Putty Basic Type, which is good, because those cracks aren't going to fill themselves.
At $50 USD I can't recommend this kit. SiOresSiOcast is being hyped and pumped by all the talking heads, but it's barely better than BONES, which I won't buy any more. Stick to the white metal and more "traditional" stuff.
Good luck,
HMP
